Home > Error Codes > Dialup Networking Error Codes

Dialup Networking Error Codes

Contents

Error codes Description 655 The macro was not found in the device .inf file section. 656 The macro in the device .inf file section contains an undefined macro. 657 Ensure that no other program is using your modem 3. Make sure your landline isn't engaged with a fax or phone call. Wait a few seconds and redial. 713 No active ISDN lines are available. 714 Not enough ISDN channels are available to make the call. 715 Too many errors occurred because of http://completeprogrammer.net/error-codes/dialup-networking-error-630.html

Try this: - Open the Start Menu and then open the Control Panel. Error 718 - Timeout Error. Try this: - Check that the following files are in c:/windows/system32/ras/ and that they're read-only: pad.inf, modem.inf and switch.inf. Dialup error 652: Unrecognised response from the device. https://support.microsoft.com/en-us/kb/824864

Rain Dial Error Codes

Set up the dialler again 4. Yep! Dialup error 785: You cannot dial using this connection at logon time, because it is not configured to use a smart card. Error #1382 Error Message: Maximum length exceeded.

A consolidated list of common windows problems and solutions is useful for a user when they encounter an error. The likes of "the computer is not receiving a response from the (other) modem"; "The computer you're dialing into is not responding" (notice similarity to previous one); "You have been disconnected Try this: - Open your Start Menu and select Search. Dial Up Modem Troubleshooting Check the event log. 752 A syntax error was encountered while processing a script Back to Top Copyright © 1999-2002 Romulus 2.

Try to reboot your computer 2. Irritrol Rain Dial Error Codes Install Blue Frog connection software again 2. This article will provide basic troubleshooting for all dialup errors for Windows, plus there may be some more specific troubleshooting steps in the list of errors (if available). Rebooting the computer will often solve the problem in that case.

Dialup errors Finding something in this list While looking at this web page, hold down the CTRL key (PC) or Command key (Mac) on your keyboard and then tap the F Rain Dial Troubleshooting Fus Usually re-doing your settings solves the issue. Install Blue Frog connection software again Error #633 Error Message: The port is already in use or is not configured for Remote Access dialout. In your "Port Settings", check that FIFO is not set to low 3.

Irritrol Rain Dial Error Codes

Visit now Z7_3054ICK0KGTE30AQO5O3KA30H4 hp-feedback-banner-portlet Actions ${title} Loading... http://www.modemhelp.net/dunerror/dunerrorcodes.shtml Another computer might already be logged on using the same logon. 643 A network adapter at the server failed. 644 You will not receive network message popups. 645 Internal authentication error. Rain Dial Error Codes Dialup error 796: The service type RADIUS attribute for this user is neither framed nor callback framed. Dial Up Troubleshooting Ensure that you set the right configurations for the dialler and network settings Error #613 Error Message: Invalid compression specified.

The file rasphone.pbk might be missing or corrupt (NT, XP only). 623 Cannot find the phone book entry. this page Dialup error 659: The media .INI file refers to an unknown device name. Error codes Description 636 The wrong device is attached to the port. Try another search Call us on 13 22 58 Tweet us at @iinet Personal Bundles Naked DSL NBN Broadband Plans Mobile Phone Plans Mobile Broadband Home Phone iiNet TV Plan Selector Dial Up Internet Troubleshooting

Check to make sure your modem is working. 682 ERROR WRITING SECTIONNAME. 683 ERROR WRITING DEVICETYPE. 684 ERROR WRITING DEVICENAME. 685 ERROR WRITING MAXCONNECTBPS. 686 ERROR WRITING MAXCARRIERBPS. 687 ERROR WRITING Solution: 1. Dialup error 743: The remote server requires encryption. get redirected here Dialup error 792: The L2TP connection attempt failed because security negotiation timed out.

Try to check your network settings and modify your computer name 2. Troubleshooting Dial Peers One comma in the dialling sequence will make the modem pause for one second. - For example, if you have to dial 0 and then wait 2 seconds before dialling the Else, reinstall RAS/DUN 5.

Please try another.

Dialup error 631: The port was disconnected by the user. The file rasphone.pbk might be missing or corrupt (NT, XP only). 622 Cannot load the phone book file. Dialup error 613: Invalid compression specified. Vpn Error Codes Remove before attempting to enable ICS. 783 ICS cannot be enabled.

Dialup error 760: An error occurred while routing capabilities were being enabled. More than one of the same IP Addresses exist on the same private LAN. See if TCP/IP is available to install. - If TCP/IP isn't there, please contact your operating software provider for help on installing it. http://completeprogrammer.net/error-codes/dial-up-networking-error-codes.html Try to reboot your system 2.

And the good thing is that for the most part this all can be done easily enough. Hand-held device linking software might be active. 646 The account is not permitted to log on at this time of day. 647 The account is disabled. 648 The password has expired. Ensure that you have entered the proper username and password 2. Connection speed might be too fast for line quality. 641 The server cannot allocate NetBIOS resources needed to support the client. 642 One of your NetBIOS names is already registered on

If you're not sure how to do this, please contact support for your antivirus software provider. Dialup error 721: Remote PPP peer is not responding. Try this: - Hold down the CTRL, ALT + DELETE keys on your keyboard and open the Task Manager. Error codes Description 694 ERROR DCB NOT FOUND. 695 ERROR STATE MACHINES NOT STARTED. 696 ERROR STATE MACHINES ALREADY STARTED. 697 ERROR PARTIAL RESPONSE LOOPING. 698 A response keyname in the

Dialup error 612: The router is not allocated. However they do not provide more detail that would be more indicative of the issues. Check that your connection and network settings have correctly been configured 2. Your modem might not be working properly.

Dialup error 789: The L2TP connection attempt failed because the security layer encountered a processing error during initial negotiations with the remote computer. Error #787 Error Message: The L2TP connection attempt failed because the security layer could not authenticate the remote computer. Shut down some programs or applications and try again. 665 The port is not configured for Remote Access. 666 Your modem (or other connecting device) is not functioning. 667 Cannot read Dialup error 625: Invalid information found in the phone book.

Errors 720/731 - Configuration error. Else, try another Access number 4. Ensure that all authorisation is allowed in your connection settings in the Security section 2. Try this: - The LAN connection selected as the private network is either not present, or is disconnected from the network.

The main fix here is a Re-installation of Dial-Up Networking in Windows. Check your ADSL line as it is probably not synchronized 2. You should then consult your computer manufacturer Error #602 Error Message: The port is already open Solution: 1. Dialup error 684: ERROR WRITING DEVICENAME.