OptiPlex audible Beep codes In addition to the various types of diagnostics LEDs, there are a number of audible beep codes across all the models of these systems. Run the Dell Diagnostics Reboot the computer and run the Dell Diagnostics. Clean the drive Use a commercially available cleaning kit. Reinstall the memory modules and, if necessary, replace them. weblink
The technician will need this information to help you further. If you have been listening to MP3 songs, ensure that you did not turn the player volume down or off. Insert a floppy disk into the drive and try again. Memory data line failure at address, read value expecting value A memory module may be faulty or improperly seated. http://www.dell.com/support/article/us/en/04/SLN284978/en
Reseat any installed graphics cards. Read fault The operating system cannot read from the floppy or hard drive, the computer could not find a particular sector on the disk, or the requested sector is defective. Test the electrical outlet Ensure that the electrical outlet is working by testing it with another device, such as a lamp. If any of the diagnostics tests fail, the card you just reinstalled is faulty and needs to be replaced.
You have feet in your shoes. For a USB printer, ensure that the Print to the following port(s): setting is USB. Still open if any to ideas to check on. Dell Dimension 2400 Abcd Error Codes Hard drive problems Test the hard drive Windows XP Run the chkdsk utility: Click the Start button, select Shutdown, and click Restart the Computer.
If you have reinstalled all of the cards and the problem is not resolved, contact Dell. Dell Post Code Abcd but on the front of my desktop the green and orange light are constantly on and my system don't come up… and all the Diagnostic Lights are off.. Test the drive with another DVD Insert another DVD to eliminate the possibility that the original DVD is defective. http://en.community.dell.com/support-forums/desktop/f/3514/t/17535910 If the computer boots, add the peripheral cards back one by one until you find the bad one.
Straighten bent pins. Dell Gx260 Abcd Error Codes A B C D -- No lights indicates the system is getting no power. LED pattern (1 2 3 4) LED description Power LED State description 1- Off2- Off3- Off4- Off System is not plugged into AC, PSU is not plugged into system board, or they look like little colored aluminum cylinders.
Adjust the Power Properties Your computer may be in standby or hibernate mode. Plug in your computer and reboot it. Dell Gx280 Error Codes Abcd Enter system setup and ensure that the computer configuration information for the hard drive is correct. Dell Abcd Lights See "Drive Problems" for troubleshooting suggestions.
If any of the tests fail, contact Dell. have a peek at these guys Look at the diagnostic LEDs for further information. If the battery still does not work properly, contact Dell. Diagnostic LEDs for the OptiPlex series (Prior to 2005) This series of systems had a block of A, B, C, D LEDs on the back of the chassis that lit up Dell Optiplex Error Codes Abcd
You could identify these models by their flat black front face and grey side panels/lids. You can identify these systems by the fact that there is no Diagnostics LED block on the front of the unit. Registered User regular July 2008 edited July 2008 Horus wrote: » So far I got the sequence and a translation but was based on the XSL Dell models since I don't check over here I...
If none of the card failed, replace the motherboard. Dell Diagnostic Lights You might lose data if you are unable to perform an operating system shutdown. Horus on July 2008“You have brains in your head.
Close the computer cover, reconnect the computer and devices to electrical outlets, and turn them on. Try closing all programs before writing to the CD-RW. It had developed booting problem during the last few months. Dell Precision Abcd Error Codes Reseat the power cable in the power connector on the back of the computer and the electrical outlet.
Seriously though.Our rules have been updated and given their own forum. Go and look at them! The manual should tell you all of the various codes. this content See "Drive Problems" for troubleshooting suggestions.
Another failure has occurred. Remove keyboard extension cables and connect the keyboard directly to the computer. If there is an error message on the screen identifying a problem with a device (such as the floppy drive or hard drive), check the device to make sure it is Look at the diagnostic LEDs for further information.
Clear CMOS. So far I got the sequence and a translation but was based on the XSL Dell models since I don't know what model is my dell. For instructions on which cables should be attached to specific connectors on a card, see the card's documentation. The error codes mean nothing unless it stays on one.