Home > Dell Optiplex > Dell Optiplex 745 Error Codes 3 4

Dell Optiplex 745 Error Codes 3 4

Contents

Solid green power light and no beep code and no video during POST The monitor or the graphics card may be faulty or incorrectly installed. This beep code tells you that the computer encountered a memory problem. If the message is not listed, see the documentation for the operating system or the program that was running when the message appeared. Meer weergeven Laden... this content

Your ram may be just fine and fully compatible but the motherboard is simply not responding correctly. NOTE: If you see a message stating that no diagnostics utility partition has been found, run the Dell Diagnostics from your optional Drivers and Utilities CD. The symptoms don't point to memory, try a PCI graphics card to verify that the onboard video isnt dead. If the computer has a graphics card, remove the card, reinstall it, and then restart the computer. http://en.community.dell.com/support-forums/desktop/f/3514/t/19355664

Dell Optiplex 745 Error 1 3 4

Back to Top 4. Or test the mobo ouside the case, on a wooden (non conductive) surface clean the system from dust, then test with the minimum setup - disconnect also all peripherals and network Select the Boot from CD-ROM option from the menu that appears.

A possible system board failure has occurred. If the problem persists, reinstall the card you removed, then remove a different card and restart the computer. If the computer boots, add the peripheral cards back one by one until you find the bad one. Dell Optiplex 960 Error Codes 3 And 4 Try removing it and clean out the slot with a soft brush or an 'aircan'.

If none of the memory failed, replace the motherboard. Dell Optiplex 745 Diagnostic Lights 1 3 4 Memory modules are detected, but a memory failure has occurred. Click Performance and Maintenance and click System.

Try These Steps!

Such opinions may not be accurate and they are to be used at your own risk. Dell Optiplex Gx620 Error Codes Boots up fine now, thanks very much. Diagnostic LEDs for the OptiPlex series (2009 to 2012) With this series, the diagnostic LEDs changed to include a combination of the Power button LED state and the diagnostic LED indicators. cclla1 72.582 weergaven 17:39 Dell Optiplex 390 Diagnostic Code 3 - Duur: 3:54.

Dell Optiplex 745 Diagnostic Lights 1 3 4

Discussion in 'Computer Memory and Hard Drives' started by lilbit13007, Oct 19, 2011. https://www.scribd.com/doc/55908294/Dell-OptiPlex-745-Quick-Reference-Guide Inloggen 3 Laden... Dell Optiplex 745 Error 1 3 4 Inloggen Transcript Statistieken 17.538 weergaven 79 Vind je dit een leuke video? Dell Optiplex 745 Error Codes 1 2 3 Deze functie is momenteel niet beschikbaar.

Check the diagnostic lights to see if the specific problem is identified (see Diagnostic Lights). http://completeprogrammer.net/dell-optiplex/dell-optiplex-330-error-codes-3-4.html If the error message appears again, see the software documentation for additional troubleshooting suggestions. Subscribe to our monthly newsletter for tech news and trends Membership How it Works Gigs Live Careers Plans and Pricing For Business Become an Expert Resource Center About Us Who We Press the power button, move the mouse, or press a key on the keyboard to wake the computer. Dell Optiplex 755 Error Codes 3 And 4

These LEDs do not indicate the problem that caused the POST routine to stop. If identified the storage failed, replace the storage. Another failure has occurred. have a peek at these guys We explain the basics for creating useful threat intelligence.

blown capacitors), but now I no longer get the beeps. Dell Optiplex Gx280 Error Codes Solid Amber The second state of the LED at power up, indicates that the POWER_GOOD signal is active and it is probable that the power supply is fine. Microsoft® Windows® XP To resolve incompatibilities using Device Manager: Click the Start button and click Control Panel.

A filename cannot contain any of the following characters: \ / : * ? " < > | — Do not use these characters in filenames.

It turns out, it wasn't the RAM. Attachment failed to respond — See Drive Problems. No memory modules were detected. Dell 745 Beep Codes I have a desktop Dell Optiplex 745 I'm trying to fix for a friend, and I cannot even get it to "boot up".

Diskette subsystem reset failed — Run the Dell Diagnostics (see Dell Diagnostics). No boot sector on hard-disk drive — Enter system setup and ensure that the computer configuration information for the hard drive is correct (see Entering System Setup). Seek error — See Drive Problems. check my blog Keyboard failure — See Keyboard Problems.

To remove and then reinstall the program: Click the Start button, click Control Panel, and then click Add or Remove Programs. always possible 0 Message Author Comment by:blackm32009-10-05 ive tried changing the memory in each slot no luck i got ram from a working pc still no luck :( 0 Air temperature sensor not detected — For any computer type except the ultra small form-factor computer, ensure that all cables are securely fastened to the I/O panel and to the system Log in om ongepaste content te melden.

Replace the processor S3 MEM 2, 7 2 blinks followed by a short pause, 7 blinks, long pause, then repeats Memory failures Memory subsystem configuration activity is in progress. This is the normal power states of a functioning machine. When the computer starts normally, the patterns or codes on the lights change as the boot process completes. Learn about Dell's Built In Self Test for power - Duur: 2:57.

Off-Topic Tags How-tos Drivers Ask a Question Computing.NetForumsGeneral HardwareGeneral Solved What do the 1, 3, 4 green lights on the front Tags:Dell Optiplex 320 desktoppcproblems Monique Trujillo November 17, 2010 at optiplexSFF.jpg 0 LVL 3 Overall: Level 3 Message Expert Comment by:l_starter_l2009-10-05 Maybe get a PCI video card..to see if that works.. 0 LVL 23 Overall: Level 23 Components 8 Drive not ready — Put a floppy disk in the drive. If you can assist to troubleshoot, narrow down the issue with reseating memory and swapping a known good memory if available.

If you run a test from the Custom Test or Symptom Tree option, click the applicable tab described in the following table for more information. Log in om je mening te geven. You can customize the tests you want to run. The 1st thing I check when that happens is the power supply. 0 LVL 3 Overall: Level 3 Message Expert Comment by:l_starter_l2009-10-04 Does the power button stay green when you

pricelesstechnology 185.005 weergaven 44:07 How To Fix You Pc If It Beeps When Turned On And Won't Boot - Duur: 1:40. Open your browser and go to crashplan.com: Click get started, it’s free then Click the Download CrashPlan button: Click save in Internet Explorer, the… Windows 8 PCs Storage Software Cloud Computing IIRC, this is a DDR2/533 memory configuration and should run fine in single module mode. Pb Technologies 5.596 weergaven 1:38 Meer suggesties laden...

lilbit13007, Oct 19, 2011 #1 claptonman New Member Messages: 5,480 You could try pulling one of the sticks out of the second slot and see what happens, then replace it with No harm intended. Note: Please be aware that if your system completes POST without stopping on a particular error code and then gives a black screen, the most likely reason is that you are When the DELL logo appears, press immediately.