Bypass power strips, power extension cables, and other power protection devices to verify that the computer turns on properly. If the hard drive is your boot device, ensure that the drive is installed, properly seated, and partitioned as a boot device. Ja Nee Stuur ons feedback Feedback bevat ongeldig teken, speciale tekens die niet worden geaccepteerd zijn <> () \ Feedback verzenden Excuses, ons feedbacksysteem is momenteel offline. Run the Hard Disk Drive tests in the Dell Diagnostics. http://completeprogrammer.net/dell-optiplex/dell-optiplex-bios-error-codes.html
Diskette read failure See Drive Problems. If the computer boots, add the peripheral cards back one by one until you find the bad one. Jack Like 0 You have posted to a forum that requires a moderator to approve posts before they are publicly available. If you can assist to troubleshoot, narrow down the issue by removing one by one the storages on motherboard to determine which one failed. http://en.community.dell.com/support-forums/desktop/f/3514/t/19355664
Seek error See Drive Problems. If multiple versions are listed, select the version appropriate for your computer. Operations Technician at a retail company. Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
Back to Top 4. Solder the GREEN wires back together but putting your seperate peice of wire inbetween them 7. Power Button LEDs Power Button LED State Description Off Power is Off. Dell Optiplex 745 Bios Upgrade You will not get any display if the system cannot access the memory and that is what the error code indicates.
Bev. Dell Optiplex 745 Bios Reset Reseat the power cable in the power connector on the back of the computer and the electrical outlet. Cut it at around the middle 4. find more info When the boot device list appears, highlight IDE CD-ROM Device and press
Read fault The operating system cannot read from the floppy or hard drive, the computer could not find a particular sector on the disk, or the requested sector is defective. Dell Optiplex 745 Bios Password Memory odd/even logic failure at address, read value expecting value A memory module may be faulty or improperly seated. Then, shut down the computer, reinstall the hard drive, and restart the computer. Shut down the computer, remove the hard drive, and boot the computer from a CD.
If the computer still fails to boot, inspect the CPU socket for damage.
Run the Windows error-checking utility to check the file structure on the hard drive. Dell Optiplex 745 Bios Beep Codes Rhythm guitarist for the band Headspill. Dell Optiplex 745 Bios Settings The message is usually followed by specific information-for example, Printer out of paper.
Note : Please click on the title of the section you want to open below, in order to see the contents. news Not a boot diskette The operating system is trying to boot to a floppy disk that does not have a bootable operating system installed on it. Invalid configuration information – please run SETUP program The computer configuration information does not match the hardware configuration. If the computer boots, add the peripheral cards back one by one until you find the bad one. Dell Optiplex 745 Bios Update
Then shut down your computer and try again. The BIOS will turn the LED to this states to indicate it has started fetching op-codes. Operations Technician at a retail company. have a peek at these guys You could identify these system by their flat black and grey front face.
Reinstall the memory modules and, if necessary, replace them. Dell Optiplex 745 Bios Update Download Write fault The operating system cannot write to the floppy or hard drive. A possible graphics card failure has occurred.
The computer is in a normal on condition. I have a Dell Desktop computer. The message is most likely to occur after a memory module is installed. Dell Optiplex 745 Bios Password Jumper Disconnect the power cable from the wall.
See the program documentation for installation instructions. When the tests are completed, if you are running the Dell Diagnostics from the Drivers and Utilities CD, remove the CD. Several functions may not work. check my blog If the problem persists, the system board / system board component is probably bad.
Remove and then reinstall the program. i have checked the monitor with another pc all working fine please help. 0 Question by:blackm3 Facebook Twitter LinkedIn Google LVL 91 Active today Best Solution bynobus my troubleshooting procedure would HARD-DISK DRIVE READ FAILURE The hard drive may be defective. When the Dell Diagnostics Main Menu appears, select the test you want to run (see Dell Diagnostics Main Menu). ----------------------------------------------------------------------------- NOTE: If you see a message stating that no diagnostics
If the problem persists, contact Dell Technical Support. Back to top #10 petewills petewills Members 1,369 posts OFFLINE Gender:Male Location:Birmingham, UK Local time:01:06 AM Posted 03 October 2013 - 09:09 AM Why not do as the Dell Rep A possible expansion card failure has occurred. When the boot device list appears, highlight Boot to Utility Partition and press
The delay between each beep is 300ms. To resolve incompatibilities using the Windows XP Hardware Troubleshooter: Click the Start button and click Help and Support. DECREASING AVAILABLE MEMORY One or more memory modules may be faulty or improperly seated. Ensure that the display is connected and powered on.